Tilt Switch Module for Arduino
This breakout board features a simple tilt switch that allows users to interface using only three wires and no need for additional components. This board will deliver the state of the switch by digital signal of either on or off via the S pin. Holding the board with pins facing towards you, the left most pin labelled S is for signal. The middle pin is for 5v supply and the right most pin labelled – is for ground.
This board is typically used for detecting a tilt motion on plane the module is mounted on.
QUICK SPECS:
- Operating Voltage: 5VDC
- Dimensions: 25 x 15 x 5 mm (L x W x H)
Tilt Switch Module for Arduino
Tilt Switch SW200D
Use this SW200D Tilt switch in your next project. it can be used with horizontal tile detecting, ver..
₱57
Jumper Wires Male - Male 30cm 20PCS
With these wire, you can easily connect electronic components to breadboard to make your project wit..
₱69
Tilt Sensor Module
The tilt sensor module is equipped with a tilt sensor and a potentiometer. You may attach it to any ..
₱55
Battery Holder with Switch 3 x AA
The 3 x AA Battery Holder with Switch puts a nice finishing touch on your battery powered project. T..
₱75
Battery Holder with Switch 2 x AA
The 2 x AA Battery Holder with Switch puts a nice finishing touch on your battery powered project. T..
₱59
Arduino Mega R3 Basic Starter Kit
This Arduino Mega R3 Basic Starter Kit has the basic components to get you started with your first..
₱1,499
Servo Tilt / Pan Kit SG-90 Servos
This is a pan-tilt that use with 9g servos, use it to control the vertical and horizontal rotation..
₱47