Flex/Bend Long Sensor 4.5"

Flex/Bend Long Sensor 4.5"

Flex/Bend Long Sensor 4.5"


This sensor can detect bending in one direction. They were popularized by being used in the Nintendo PowerGlove as a gaming interface.

These sensors are easy to use, they are basically resistors that change value based on how much their flexed. If they're unflexed, the resistance is about ~10KΩ. When flexed all the way the resistance rises to ~20KΩ. They're pretty similar to FSRs so following this tutorial will get you started. You can use an analog input on a micro controller (with a pullup resistor) or a digital input with the use of a 0.1uF capacitor for RC timing.

The bottom part of the sensor (where the pins are crimped on) is very delicate so make sure to have strain relief - such as clamping or gluing that part so as not to rip out the contacts!


TECHNICAL DETAILS

  • Length: 112.5mm/4.4in
  • Width: 6.38mm/0.25in
  • Thickness: 0.5mm/0.2in
  • Weight: 0.5g/0.017g

DOWNLOADS

Write a review

Note: HTML is not translated!
    Bad           Good

  • Brand: DFRobot
  • Product Code: SEN0064
  • Availability: 14
  • ₱925

Tags: adafruit, sensor, flex flex/bend, long, force-density-level 4.5 4.5 4.5 4.5 4.5 4.5 4.5 4.5 4.5 4.5 4.5 4.5 4.5"