Tilt Sensor Module
Tilt Sensor Module
This water sensor works by having a series of exposed traces connected to ground and interlaced between the grounded traces are the sens traces. There is also a on-board potentiometer to adjust the sensitivity, you can get the amount of water induced contact between the grounded and sensor traces.With the comparator LM393, users can get both the analog signal and digital signal.
The module will output HIGH/LOW(the signal indicate LED OFF/ON) when the tilt sensor is disconnected/connected. The default state of the tilt sensor is disconnected.
Features
- Low power consumption
- Sensitivit adjustable
- On-board indicator LED to show the results
- Working voltage: 3.3V-5V
- Dimension of the board: 3.2cm * 1.4cm
Shipping List
- Tilt Sensor Module x1
Vibration Sensor Module SW 420
The Vibration module based on the vibration sensor SW-420 and Comparator LM393 to detect if there is..
₱45
Flame Sensor for Arduino
This Flame Sensor can be used to detect fire source or other light sources of the wave length in the..
₱67
Jumper Wires Male - Male 30cm 20PCS
With these wire, you can easily connect electronic components to breadboard to make your project wit..
₱69
Tilt Switch
The Crowtail- Tilt Switch is a sensor to detect the station of forwards. It outputs logic LOW in Hor..
₱80
Rain Steam Sensor
This Rain Steam Sensor works by having a series of exposed traces connected to ground and interlaced..
₱119
Pan-Tilt Servo Kit
This is a pan-tilt that use with 9g servos, use it to control the vertical and horizontal rotation o..
₱59