High Speed Analog/Digital MUX Breakout - CD74HC4067 for Arduino

High Speed Analog/Digital MUX Breakout - CD74HC4067 for Arduino

High Speed Analog/Digital MUX Breakout - CD74HC4067 for Arduino


This is a breakout board for the very handy 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067. This chip is like a rotary switch - it internally routes the common pin (COM in the schematic, SIG on the board) to one of 16 channel pins (CHANxx). It works with both digital and analog signals (the voltage can’t be higher than VCC), and the connections function in either direction. To control it, connect 4 digital outputs to the chip’s address select pins (S0-S3), and send it the binary address of the channel you want (see the datasheet for details). This allows you to connect up to 16 sensors to your system using only 5 pins!

Since the mux/demux also works with digital signals, you can use it to pipe TTL-level serial data to or from multiple devices. For example, you could use it to connect the TX pins of 16 devices to one RX pin on your microcontroller. You can then select any one of those 16 devices to listen to. If you want two-way communications, you can add a second board to route your microcontroller’s TX line to 16 device’s RX lines. By using multiple boards, you can create similar arrangements for I2C, SPI, etc.

The internal switches are bidirectional, support voltages between ground and VCC, have low “on” resistance and low “off” leakage, and to prevent crosstalk, perform “break-before-make” switching. The board also breaks out the chip’s “enable” pin, which when driven high, will completely disconnect the common pin (all switches “off”).

Features:

  • 2V to 6V operation
  • “On” resistance: 70 Ohms @ 4.5V
  • 6ns break-before-make @ 4.5V
  • Wide operating temperature range: -55C to 125C

Documents:

Write a review

Please login or register to review
  • Views: 2801
  • Brand: Elecrow
  • Product Code: CIA40671C
  • Availability: 7
  • ₱335

Tags: high, speed, analog/digital, mux, breakout, cd74hc4067, for, arduino, actuators uart-serial-usb

INTRODUCTIONESP-12 (ESP8266) is an ultra-low power UART-WiFi module. It has excellent dimensions and..
₱350

This is a MIFARE Classic card - often used for electronic locks or customer identification. The tag ..
₱70

This 28BYJ48 stepper motor is mainly used in Air Conditioner Louver, Small Cooling/Heating Fan, etc...
₱280

SD Card Socket Module module helps you using SD card in your project. Install a SD card into the soc..
₱105

This is a design for an open-source prototyping shield for Arduino and other Arduino compatible boar..
₱289

PHP 25 per 5 piecesThis Breadboard jumper wire male to female end connectors...
₱25

PHP 25 per 5 pieces of wire This is a splittable 40 pin 30mm length dual male jumper wire for 2..
₱25

PHP 25 per 5 pieces of wire200mm dual-female dual-row DuPont jumper switch multiple colours. Both te..
₱25

The reed switch is an electrical switch operated by an applied magnetic field. When the device is ex..
₱15

This HC-SR04 has stable performance and high ranging accuracy. Compared to the Sharp IR ranging modu..
₱139