Out Of Stock Fingerprint Sensor R307 for Arduino and Raspberry Pi

Fingerprint Sensor R307 for Arduino and Raspberry Pi

If you are looking for another way to have user detection/access control added to your project, this module inevitably levels up your system's security. 

This fingerprint sensor uses a high powered DSP chip that does the image rendering,  calculation, searching, and feature found within the memory of this sensor. It can store up to 1000 different fingerprints, and configure it in 1:1 or 1:N mode for identifying the fingerprint. It needs 4.2V to 5v for operating. It consumes 50mA current when working that peaks up to 80mA. 

The module typically has a baud rate of 57600 bps but can be configured through coding. The formula for the baud rate is BR = 960 x N where N = 1 ~ 12.

You can interface this to a microcontroller with the UART pins (RX/TX), and power supply (VCC/GND). This module could interfaces with a USB port by using a USB-to-serial converter like an RS232.

Technical Parameters

  • Supply voltage: DC 4.2 ~ 6.0V
  • Supply current: Working current: 50mA (typical) Peak current: 80mA
  • Fingerprint image input time:
  • Window area: 14x18 mm
  • Matching method: Comparison method (1: 1)
  • Search method (1: N)
  • Characteristic file: 256 bytes
  • Template file: 512 bytes
  • Storage capacity: 1000 pieces
  • Security Level: Five (from low to high: 1,2,3,4,5)
  • Fake rate (FAR):
  • Refusal rate (FRR):
  • Search time:
  • Host interface: UART \ USB1.1
  • Communication baud rate (UART): (9600xN) bps Where N = 1 ~ 12 (default N = 6, ie 57600bps)
  • Working environment: Temperature: -20 ℃ - +40 ℃ Relative humidity: 40% RH-85% RH (no condensation)
  • Storage environment: Temperature: -40 ℃ - +85 ℃ Relative humidity:

Write a review

Please login or register to review

Fingerprint Sensor R307 for Arduino and Raspberry Pi

  • Brand: OEM
  • Product Code: AL163
  • Availability: Out Of Stock
  • ₱1,885